SIB Standalone Keypad Access Control User Manual

Standalone Keypad Access ControlUser ManualPlease read the manual carefully before use this unit

1011.2 Door SettingsRelay Output Delay TimeTo set door relay strike time0-99 is to set the door relay time 0-99 secondsDoor Open DetectionDoor Open To

1112.The unit operating as a Wiegand Output ReaderIn this mode the unit supports a Wiegand 26 bit output so the Wiegand data lines can beconnected to

12

21. Packing ListName Quantity RemarksKeypad 1User manual 1Screw driver 1Φ20mm×60mm,Special for keypadRubber plug 2Φ6mm×30 mm, used for fixingSelf tapp

3programming modeTo unlock the door for a PIN user Enter the then pressTo unlock the door for a card user Present the card3. DescriptionThe unit is si

45. SpecificationsOperating VoltageDC 12V±10%User Capacity 2000Card Reading Distance 3-6 cmActive Current＜60mAIdle Current 25±5 mALock Output Load Max

57. WiringColour Function DescriptionPink BELL_A Doorbell button one endPale blue BELL_B Doorbell button to the other endGreen D0 WG output D0White D1

6special power supply diagram:8. To Reset to Factory Defaulta. Disconnect power from the unitb. Press and hold # key whilst powering the unit back upc

7modeOpen the door - Bright - D iAlarm Bright - - Alarm11. Detailed Programming Guide11.1 User SettingsTo enter the programming mode999999 is the defa

8To add a card user (Method 2)This is the alternative way to enter cardsusing User ID Allocation. In this method aUser ID is allocated to a card. Only

9programming mode so the user canundertake this themselvesTo delete a Card and PIN user just deletethe cardTo add a card user in card mode ( )To Add a