SIB Standalone Keypad Access Control User Manual download pdf (Page 6)

special power supply diagram:

8. To Reset to Factory Default

a. Disconnect power from the unit

b. Press and hold # key whilst powering the unit back up

c. On hearing two “Di” release # key, system is now back factory settings

Please note only installer data is restored, user data will not be affected

9. Anti Tamper Alarm

The unit uses a LDR (light dependent resistor) as an anti tamper alarm. If the keypad is

removed from the cover then the tamper alarm will operate.

10.Sound and Light indication

Operation Status Red Light Green Light Yellow Light Buzzer

Power on - Bright - Di

Stand by Bright - - -

Press keypad - - - Di

Operation successful - Bright - Di

Operation failed - - - DiDiDi

Enter into programming mode Bright - -

In the programming mode - - Bright Di

Exit from the programming Bright - - Di

1 2 3 4 5 6 7 8 9 10 11 12

No comments

SIB Standalone Keypad Access Control User Manual Page 6